[dpdk-dev] [PATCH v2] net/pcap: propagate timestamp from pcap_pkthdr to mbuf

[Sylvain Rodon <srn@nexatech.fr>]

From: Sylvain Rodon <srn@nexatech.fr>

Timestamp is always set in PCAP header, whether it reads a file or
listen on an interface. This information can be important for some
applications and it cannot be obtained otherwise (especially when
reading a PCAP file, where the timestamp is not the current time).
Timestamp here is the number of microseconds since epoch.

Signed-off-by: Sylvain Rodon <srn@nexatech.fr>
---
 drivers/net/pcap/rte_eth_pcap.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/pcap/rte_eth_pcap.c b/drivers/net/pcap/rte_eth_pcap.c
index 95d4b5b..5489010 100644
--- a/drivers/net/pcap/rte_eth_pcap.c
+++ b/drivers/net/pcap/rte_eth_pcap.c
@@ -265,6 +265,9 @@ struct pmd_devargs_all {
 		}
 
 		mbuf->pkt_len = (uint16_t)header.caplen;
+		mbuf->timestamp = (uint64_t)header.ts.tv_sec * 1000000
+							+ header.ts.tv_usec;
+		mbuf->ol_flags |= PKT_RX_TIMESTAMP;
 		mbuf->port = pcap_q->port_id;
 		bufs[num_rx] = mbuf;
 		num_rx++;
-- 
1.9.1