[dpdk-dev] [PATCH] net/octeontx2: fix exit paths after cq init

[Anoob Joseph <anoobj@marvell.com>]

After otx2_nix_register_cq_irqs() is called and the IRQs are setup,
otx2_nix_unregister_cq_irqs() need to be called in the subsequent error
exit paths.

Fixes: d34db5ccbf30 ("net/octeontx2: fix driver reconfiguration")

Signed-off-by: Anoob Joseph <anoobj@marvell.com>
---
 drivers/net/octeontx2/otx2_ethdev.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/octeontx2/otx2_ethdev.c b/drivers/net/octeontx2/otx2_ethdev.c
index aab34db..18aa0f5 100644
--- a/drivers/net/octeontx2/otx2_ethdev.c
+++ b/drivers/net/octeontx2/otx2_ethdev.c
@@ -1700,13 +1700,13 @@ otx2_nix_configure(struct rte_eth_dev *eth_dev)
 	rc = cgx_intlbk_enable(dev, eth_dev->data->dev_conf.lpbk_mode);
 	if (rc) {
 		otx2_err("Failed to configure cgx loop back mode rc=%d", rc);
-		goto q_irq_fini;
+		goto cq_fini;
 	}
 
 	rc = otx2_nix_rxchan_bpid_cfg(eth_dev, true);
 	if (rc) {
 		otx2_err("Failed to configure nix rx chan bpid cfg rc=%d", rc);
-		goto q_irq_fini;
+		goto cq_fini;
 	}
 
 	rc = otx2_nix_mc_addr_list_install(eth_dev);
-- 
2.7.4