[dpdk-dev] [PATCH v4 32/34] net/bnxt: disable vector mode when host based TRUFLOW is enabled

[Venkat Duvvuru <venkatkumar.duvvuru@broadcom.com>]

If bp->truflow is not set then don't enable vector mode.

Signed-off-by: Venkat Duvvuru <venkatkumar.duvvuru@broadcom.com>
Reviewed-by: Lance Richardson <lance.richardson@broadcom.com>
Reviewed-by: Ajit Kumar Khaparde <ajit.khaparde@broadcom.com>
---
 drivers/net/bnxt/bnxt_ethdev.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/bnxt/bnxt_ethdev.c b/drivers/net/bnxt/bnxt_ethdev.c
index 783e6a4..5d5b8e0 100644
--- a/drivers/net/bnxt/bnxt_ethdev.c
+++ b/drivers/net/bnxt/bnxt_ethdev.c
@@ -788,7 +788,8 @@ bnxt_receive_function(struct rte_eth_dev *eth_dev)
 		DEV_RX_OFFLOAD_TCP_CKSUM |
 		DEV_RX_OFFLOAD_OUTER_IPV4_CKSUM |
 		DEV_RX_OFFLOAD_RSS_HASH |
-		DEV_RX_OFFLOAD_VLAN_FILTER))) {
+		DEV_RX_OFFLOAD_VLAN_FILTER)) &&
+	    !bp->truflow) {
 		PMD_DRV_LOG(INFO, "Using vector mode receive for port %d\n",
 			    eth_dev->data->port_id);
 		bp->flags |= BNXT_FLAG_RX_VECTOR_PKT_MODE;
-- 
2.7.4