From: Stephen Hemminger <stephen@networkplumber.org>
To: dev@dpdk.org
Cc: Stephen Hemminger <stephen@networkplumber.org>,
Hemant Agrawal <hemant.agrawal@nxp.com>,
Sachin Saxena <sachin.saxena@nxp.com>
Subject: [RFT 1/3] net/dpaa2: remove unused frame array
Date: Wed, 15 Oct 2025 16:07:37 -0700 [thread overview]
Message-ID: <20251015230933.875860-2-stephen@networkplumber.org> (raw)
In-Reply-To: <20251015230933.875860-1-stephen@networkplumber.org>
The frame attribute variables were global but never used.
Tried making them local, but then compiler flags as unused
so remove them.
Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
---
drivers/net/dpaa2/dpaa2_sparser.c | 117 ------------------------------
1 file changed, 117 deletions(-)
diff --git a/drivers/net/dpaa2/dpaa2_sparser.c b/drivers/net/dpaa2/dpaa2_sparser.c
index 265c9b5c57..0b3e9f1920 100644
--- a/drivers/net/dpaa2/dpaa2_sparser.c
+++ b/drivers/net/dpaa2/dpaa2_sparser.c
@@ -28,123 +28,6 @@ uint8_t wriop_bytecode[] = {
0x18, 0x00, 0x87, 0x3c, 0x00, 0x02, 0x18, 0x00, 0x00, 0x00
};
-struct frame_attr frame_attr_arr[] = {
- /* Frame Attribute Flags 1 */
- /* 000 */ {"Routing header present in IPv6 header 2 ", 0, 0x80000000},
- /* 001 */ {"GTP Primed was detected ", 0, 0x40000000},
- /* 002 */ {"VLAN with VID = 0 was detected ", 0, 0x20000000},
- /* 003 */ {"A PTP frame was detected ", 0, 0x10000000},
- /* 004 */ {"VXLAN was parsed ", 0, 0x08000000},
- /* 005 */ {"A VXLAN HXS parsing error was detected ", 0, 0x04000000},
- /* 006 */ {"Ethernet control protocol was detected ", 0, 0x02000000},
- /* 007 */ {"IKE was detected at UDP port 4500 ", 0, 0x01000000},
- /* 008 */ {"Shim Shell Soft Parsing Error ", 0, 0x00800000},
- /* 009 */ {"Parsing Error ", 0, 0x00400000},
- /* 010 */ {"Ethernet MAC Present ", 0, 0x00200000},
- /* 011 */ {"Ethernet Unicast ", 0, 0x00100000},
- /* 012 */ {"Ethernet Multicast ", 0, 0x00080000},
- /* 013 */ {"Ethernet Broadcast ", 0, 0x00040000},
- /* 014 */ {"BPDU frame (MAC DA is 01:80:C2:00:00:00)", 0, 0x00020000},
- /* 015 */ {"FCoE detected (Ether type is 0x8906) ", 0, 0x00010000},
- /* 016 */ {"FIP detected (Ether type is 0x8914) ", 0, 0x00008000},
- /* 017 */ {"Ethernet Parsing Error ", 0, 0x00004000},
- /* 018 */ {"LLC+SNAP Present ", 0, 0x00002000},
- /* 019 */ {"Unknown LLC/OUI ", 0, 0x00001000},
- /* 020 */ {"LLC+SNAP Error ", 0, 0x00000800},
- /* 021 */ {"VLAN 1 Present ", 0, 0x00000400},
- /* 022 */ {"VLAN n Present ", 0, 0x00000200},
- /* 023 */ {"CFI bit in a \"8100\" VLAN tag is set ", 0, 0x00000100},
- /* 024 */ {"VLAN Parsing Error ", 0, 0x00000080},
- /* 025 */ {"PPPoE+PPP Present ", 0, 0x00000040},
- /* 026 */ {"PPPoE+PPP Parsing Error ", 0, 0x00000020},
- /* 027 */ {"MPLS 1 Present ", 0, 0x00000010},
- /* 028 */ {"MPLS n Present ", 0, 0x00000008},
- /* 029 */ {"MPLS Parsing Error ", 0, 0x00000004},
- /* 030 */ {"ARP frame Present (Ethertype 0x0806) ", 0, 0x00000002},
- /* 031 */ {"ARP Parsing Error ", 0, 0x00000001},
- /* Frame Attribute Flags 2 */
- /* 032 */ {"L2 Unknown Protocol ", 1, 0x80000000},
- /* 033 */ {"L2 Soft Parsing Error ", 1, 0x40000000},
- /* 034 */ {"IPv4 1 Present ", 1, 0x20000000},
- /* 035 */ {"IPv4 1 Unicast ", 1, 0x10000000},
- /* 036 */ {"IPv4 1 Multicast ", 1, 0x08000000},
- /* 037 */ {"IPv4 1 Broadcast ", 1, 0x04000000},
- /* 038 */ {"IPv4 n Present ", 1, 0x02000000},
- /* 039 */ {"IPv4 n Unicast ", 1, 0x01000000},
- /* 040 */ {"IPv4 n Multicast ", 1, 0x00800000},
- /* 041 */ {"IPv4 n Broadcast ", 1, 0x00400000},
- /* 042 */ {"IPv6 1 Present ", 1, 0x00200000},
- /* 043 */ {"IPv6 1 Unicast ", 1, 0x00100000},
- /* 044 */ {"IPv6 1 Multicast ", 1, 0x00080000},
- /* 045 */ {"IPv6 n Present ", 1, 0x00040000},
- /* 046 */ {"IPv6 n Unicast ", 1, 0x00020000},
- /* 047 */ {"IPv6 n Multicast ", 1, 0x00010000},
- /* 048 */ {"IP 1 option present ", 1, 0x00008000},
- /* 049 */ {"IP 1 Unknown Protocol ", 1, 0x00004000},
- /* 050 */ {"IP 1 Packet is a fragment ", 1, 0x00002000},
- /* 051 */ {"IP 1 Packet is an initial fragment ", 1, 0x00001000},
- /* 052 */ {"IP 1 Parsing Error ", 1, 0x00000800},
- /* 053 */ {"IP n option present ", 1, 0x00000400},
- /* 054 */ {"IP n Unknown Protocol ", 1, 0x00000200},
- /* 055 */ {"IP n Packet is a fragment ", 1, 0x00000100},
- /* 056 */ {"IP n Packet is an initial fragment ", 1, 0x00000080},
- /* 057 */ {"ICMP detected (IP proto is 1) ", 1, 0x00000040},
- /* 058 */ {"IGMP detected (IP proto is 2) ", 1, 0x00000020},
- /* 059 */ {"ICMPv6 detected (IP proto is 3a) ", 1, 0x00000010},
- /* 060 */ {"UDP Light detected (IP proto is 136) ", 1, 0x00000008},
- /* 061 */ {"IP n Parsing Error ", 1, 0x00000004},
- /* 062 */ {"Min. Encap Present ", 1, 0x00000002},
- /* 063 */ {"Min. Encap S flag set ", 1, 0x00000001},
- /* Frame Attribute Flags 3 */
- /* 064 */ {"Min. Encap Parsing Error ", 2, 0x80000000},
- /* 065 */ {"GRE Present ", 2, 0x40000000},
- /* 066 */ {"GRE R bit set ", 2, 0x20000000},
- /* 067 */ {"GRE Parsing Error ", 2, 0x10000000},
- /* 068 */ {"L3 Unknown Protocol ", 2, 0x08000000},
- /* 069 */ {"L3 Soft Parsing Error ", 2, 0x04000000},
- /* 070 */ {"UDP Present ", 2, 0x02000000},
- /* 071 */ {"UDP Parsing Error ", 2, 0x01000000},
- /* 072 */ {"TCP Present ", 2, 0x00800000},
- /* 073 */ {"TCP options present ", 2, 0x00400000},
- /* 074 */ {"TCP Control bits 6-11 set ", 2, 0x00200000},
- /* 075 */ {"TCP Control bits 3-5 set ", 2, 0x00100000},
- /* 076 */ {"TCP Parsing Error ", 2, 0x00080000},
- /* 077 */ {"IPSec Present ", 2, 0x00040000},
- /* 078 */ {"IPSec ESP found ", 2, 0x00020000},
- /* 079 */ {"IPSec AH found ", 2, 0x00010000},
- /* 080 */ {"IPSec Parsing Error ", 2, 0x00008000},
- /* 081 */ {"SCTP Present ", 2, 0x00004000},
- /* 082 */ {"SCTP Parsing Error ", 2, 0x00002000},
- /* 083 */ {"DCCP Present ", 2, 0x00001000},
- /* 084 */ {"DCCP Parsing Error ", 2, 0x00000800},
- /* 085 */ {"L4 Unknown Protocol ", 2, 0x00000400},
- /* 086 */ {"L4 Soft Parsing Error ", 2, 0x00000200},
- /* 087 */ {"GTP Present ", 2, 0x00000100},
- /* 088 */ {"GTP Parsing Error ", 2, 0x00000080},
- /* 089 */ {"ESP Present ", 2, 0x00000040},
- /* 090 */ {"ESP Parsing Error ", 2, 0x00000020},
- /* 091 */ {"iSCSI detected (Port# 860) ", 2, 0x00000010},
- /* 092 */ {"Capwap-control detected (Port# 5246) ", 2, 0x00000008},
- /* 093 */ {"Capwap-data detected (Port# 5247) ", 2, 0x00000004},
- /* 094 */ {"L5 Soft Parsing Error ", 2, 0x00000002},
- /* 095 */ {"IPv6 Route hdr1 present ", 2, 0x00000001},
- /* 096 */ {NULL, 0, 0x00000000}
-};
-
-struct frame_attr_ext frame_attr_ext_arr[] = {
- /* Frame Attribute Flags Extension */
- /* 096 */ {"User defined soft parser bit #0 ", 0, 0x8000},
- /* 096 */ {"User defined soft parser bit #1 ", 0, 0x4000},
- /* 096 */ {"User defined soft parser bit #2 ", 0, 0x2000},
- /* 096 */ {"User defined soft parser bit #3 ", 0, 0x1000},
- /* 096 */ {"User defined soft parser bit #4 ", 0, 0x0800},
- /* 096 */ {"User defined soft parser bit #5 ", 0, 0x0400},
- /* 096 */ {"User defined soft parser bit #6 ", 0, 0x0200},
- /* 096 */ {"User defined soft parser bit #7 ", 0, 0x0100},
- /* 097 */ {"Reserved ", 0, 0x00ff},
- /* 112 */ {NULL, 0, 0x0000}
-};
-
int dpaa2_eth_load_wriop_soft_parser(struct dpaa2_dev_priv *priv,
enum dpni_soft_sequence_dest dest)
{
--
2.47.3
next prev parent reply other threads:[~2025-10-15 23:09 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-10-15 23:07 [RFT 0/3] net/dpaa2: global symbol fixes Stephen Hemminger
2025-10-15 23:07 ` Stephen Hemminger [this message]
2025-10-15 23:07 ` [RFT 2/3] net/dpaa2: make local array static Stephen Hemminger
2025-10-15 23:07 ` [RFT 3/3] net/dpaa2: make total rx descriptors per device Stephen Hemminger
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20251015230933.875860-2-stephen@networkplumber.org \
--to=stephen@networkplumber.org \
--cc=dev@dpdk.org \
--cc=hemant.agrawal@nxp.com \
--cc=sachin.saxena@nxp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).