Re: [dpdk-dev] [PATCH v2] net/octeontx2: enable full flow control for HIGIG

[Jerin Jacob <jerinjacobk@gmail.com>]

On Thu, Jan 30, 2020 at 9:54 PM <kirankumark@marvell.com> wrote:
>
> From: Kiran Kumar K <kirankumark@marvell.com>
>
> When HIGIG flow control enabled with CGX, We are disabling Tx flow control.
> Added check to enable the full flow control in HIGIG mode.
>
> Signed-off-by: Kiran Kumar K <kirankumark@marvell.com>
> ---
> V2 changes:
> * Updated commit log

Updated the commit message to:
    net/octeontx2: fix Tx flow control for HIGIG

    Tx flow controlled is disabled in the Ax silicon version due to an errata.
    This errata is not applicable for HIGIG Tx flow control, therefore
    not enabling in HIGIG case.

    Fixes: 602009ee2dfb ("net/octeontx2: support HIGIG2")
    Cc: stable@dpdk.org

    Signed-off-by: Kiran Kumar K <kirankumark@marvell.com>

Acked-by: Jerin Jacob <jerinj@marvell.com>
Applied to dpdk-next-net-mrvl/master. Thanks



>
>  drivers/net/octeontx2/otx2_flow_ctrl.c | 1 +
>  1 file changed, 1 insertion(+)
>
> diff --git a/drivers/net/octeontx2/otx2_flow_ctrl.c b/drivers/net/octeontx2/otx2_flow_ctrl.c
> index c6d7b1971..1c6929e76 100644
> --- a/drivers/net/octeontx2/otx2_flow_ctrl.c
> +++ b/drivers/net/octeontx2/otx2_flow_ctrl.c
> @@ -213,6 +213,7 @@ otx2_nix_update_flow_ctrl_mode(struct rte_eth_dev *eth_dev)
>
>         /* To avoid Link credit deadlock on Ax, disable Tx FC if it's enabled */
>         if (otx2_dev_is_Ax(dev) &&
> +           (dev->npc_flow.switch_header_type != OTX2_PRIV_FLAGS_HIGIG) &&
>             (fc_conf.mode == RTE_FC_FULL || fc_conf.mode == RTE_FC_RX_PAUSE)) {
>                 fc_conf.mode =
>                                 (fc_conf.mode == RTE_FC_FULL ||
> --
> 2.17.1
>