Re: [dpdk-dev] [PATCH v4 02/10] examples/l2fwd-event: add infra for eventdev

[Nipun Gupta <nipun.gupta@nxp.com>]

> -----Original Message-----
> From: dev <dev-bounces@dpdk.org> On Behalf Of
> pbhagavatula@marvell.com
> Sent: Tuesday, September 24, 2019 3:12 PM
> To: jerinj@marvell.com; bruce.richardson@intel.com; Akhil Goyal
> <akhil.goyal@nxp.com>; Marko Kovacevic <marko.kovacevic@intel.com>;
> Ori Kam <orika@mellanox.com>; Radu Nicolau <radu.nicolau@intel.com>;
> Tomasz Kantecki <tomasz.kantecki@intel.com>; Sunil Kumar Kori
> <skori@marvell.com>; Pavan Nikhilesh <pbhagavatula@marvell.com>
> Cc: dev@dpdk.org
> Subject: [dpdk-dev] [PATCH v4 02/10] examples/l2fwd-event: add infra for
> eventdev
> 
> From: Sunil Kumar Kori <skori@marvell.com>
> 
> Add infra to select event device as a mode to process packets through
> command line arguments. Also, allow the user to select the schedule type
> to be either RTE_SCHED_TYPE_ORDERED or RTE_SCHED_TYPE_ATOMIC.
> 
> Usage:
> 
> `--mode="eventdev"` or `--mode="poll"`
> `--eventq-sync="ordered"` or `--eventq-sync="atomic"`
> 
> Signed-off-by: Sunil Kumar Kori <skori@marvell.com>
> ---
>  examples/l2fwd-event/Makefile         |   1 +
>  examples/l2fwd-event/l2fwd_eventdev.c | 107
> ++++++++++++++++++++++++++
>  examples/l2fwd-event/l2fwd_eventdev.h |  62 +++++++++++++++
>  examples/l2fwd-event/main.c           |  39 +++++++++-
>  examples/l2fwd-event/meson.build      |   3 +-
>  5 files changed, 209 insertions(+), 3 deletions(-)
>  create mode 100644 examples/l2fwd-event/l2fwd_eventdev.c
>  create mode 100644 examples/l2fwd-event/l2fwd_eventdev.h
> 

<snip>

> 
> @@ -288,7 +289,12 @@ l2fwd_usage(const char *prgname)
>  	       "  --[no-]mac-updating: Enable or disable MAC addresses
> updating (enabled by default)\n"
>  	       "      When enabled:\n"
>  	       "       - The source MAC address is replaced by the TX port MAC
> address\n"
> -	       "       - The destination MAC address is replaced by
> 02:00:00:00:00:TX_PORT_ID\n",
> +	       "       - The destination MAC address is replaced by
> 02:00:00:00:00:TX_PORT_ID\n"
> +	       "  --mode: Packet transfer mode for I/O, poll or eventdev\n"
> +	       "          Default mode = eventdev\n"
> +	       "  --eventq-sync:Event queue synchronization method,\n"
> +	       "                ordered or atomic.\nDefault: atomic\n"
> +	       "                Valid only if --mode=eventdev\n\n",
>  	       prgname);
>  }

'l2fwd-event' -- --help does not prints this help.