Re: [dpdk-dev] [PATCH] doc: update failsafe feature list

[Ferruh Yigit <ferruh.yigit@intel.com>]

On 9/14/2017 4:32 PM, Matan Azrad wrote:
> Add supported failsafe features to feature list.
> Remove stats per queue feature from failsafe feature list since
> queue_stats_mapping_set dev op has not implemented yet.
> 
> Signed-off-by: Matan Azrad <matan@mellanox.com>
> ---
>  doc/guides/nics/features/failsafe.ini | 15 ++++++++++++++-
>  1 file changed, 14 insertions(+), 1 deletion(-)
> 
> diff --git a/doc/guides/nics/features/failsafe.ini b/doc/guides/nics/features/failsafe.ini
> index a42e344..9f48455 100644
> --- a/doc/guides/nics/features/failsafe.ini
> +++ b/doc/guides/nics/features/failsafe.ini
> @@ -4,20 +4,33 @@
>  ; Refer to default.ini for the full list of available PMD features.
>  ;
>  [Features]
> +Speed capabilities   = Y
>  Link status          = Y
>  Link status event    = Y
>  MTU update           = Y
>  Jumbo frame          = Y
> +Scattered Rx         = Y
> +LRO                  = Y
> +TSO                  = Y
>  Promiscuous mode     = Y
>  Allmulticast mode    = Y
>  Unicast MAC filter   = Y
>  Multicast MAC filter = Y
>  VLAN filter          = Y
> +Ethertype filter     = Y
> +N-tuple filter       = Y
> +SYN filter           = Y
> +Tunnel filter        = Y
> +Flexible filter      = Y
> +Hash filter          = Y
> +Flow director        = Y
>  Flow control         = Y
>  Flow API             = Y
> +QinQ offload         = Y
> +L3 checksum offload  = Y
> +L4 checksum offload  = Y
>  Packet type parsing  = Y
>  Basic stats          = Y
> -Stats per queue      = Y
>  ARMv7                = Y
>  ARMv8                = Y
>  Power8               = Y

I am not sure if claiming support for these features is correct.
Failsafe itself doesn't provide these features, but relies underlying
hardware which we don't really know what they supports or not in this stage.

OK for dropping "Stats per queue"

>