Add diable/enable "extend off" "strip off" in test plan. Signed-off-by: Weiyuan Li --- test_plans/dual_vlan_test_plan.rst | 19 +++++++++++++------ 1 file changed, 13 insertions(+), 6 deletions(-) diff --git a/test_plans/dual_vlan_test_plan.rst b/test_plans/dual_vlan_test_plan.rst index 762147f0..ebd68d0a 100644 --- a/test_plans/dual_vlan_test_plan.rst +++ b/test_plans/dual_vlan_test_plan.rst @@ -44,6 +44,10 @@ Enable vlan filtering on port 0:: testpmd> vlan set filter on 0 +Disable extend on port 0:: + + testpmd> vlan set extend off 0 + Check whether the mode is set successful:: testpmd> show port info 0 @@ -103,6 +107,11 @@ Configure the traffic generator to send VLAN packets with the Tag Identifier Test Case: Add/Remove VLAN Tag Identifier pass VLAN filtering ============================================================= +Disable VLAN packet extend and strip port ``0``:: + + testpmd> vlan set extend off 0 + testpmd> vlan set strip off 0 + Enable VLAN filtering on port ``0``:: testpmd> vlan set filter on 0 @@ -240,12 +249,12 @@ and send 1 packet on port ``A``. Verify that the packet can been received on por ``B`` without VLAN Tag Identifier. -Test Case: Configure receive port outer VLAN TPID +Test Case: Configure receive port inner VLAN TPID ================================================= -Enable vlan header QinQ on port ``0`` firstly to support set TPID:: +Enable VLAN packet extend on port ``0``:: - testpmd> vlan set qinq on 0 + testpmd> vlan set extend on 0 Check whether the mode is set successfully:: @@ -260,9 +269,7 @@ Check whether the mode is set successfully:: Allmulticast mode: disabled Maximum number of MAC addresses: 127 VLAN offload: - strip off - filter off - qinq(extend) on + strip off, filter off, extend on, qinq strip off Set Tag Protocol ID ``0x1234`` on port ``0``. Nic only support inner model, except Intel® Ethernet 700 Series:: -- 2.27.0