Re: [dpdk-users] Virtio-user exceptional path performance

[Tiwei Bie <tiwei.bie@intel.com>]

On Tue, Sep 18, 2018 at 02:45:24PM +0000, Eric Tremblay wrote:
> Thanks for the reply.
> 
> With the patch, the tap interface is created in the kernel even when specifying the --enable-lro and --enable-rx-cksum options. However, the behaviour is the same as without these options. That is, ethtool shows LRO and rx-checksum as off (and [fixed]) and TCP traffic gets dropped unless tx-checksum is turned off. The difference is that testpmd now says that LRO and RX checksum are on (even though they don't seem to be).

Are you using csum fwd in testpmd? You also need to
enable the hw csum offload. You can do it via:

testpmd> csum set tcp hw 0
testpmd> csum set tcp hw 1

And make sure you get below output:

TCP checksum offload is hw

> 
> Eric 
> 
> -----Original Message-----
> From: Tiwei Bie <tiwei.bie@intel.com> 
> Sent: September 18, 2018 1:30 AM
> To: Eric Tremblay <ertr@kaloom.com>; users@dpdk.org
> Cc: zhihong.wang@intel.com; maxime.coquelin@redhat.com
> Subject: Re: [dpdk-users] Virtio-user exceptional path performance
> 
> On Tue, Sep 04, 2018 at 05:54:20PM +0000, Eric Tremblay wrote:
> > Hello,
> > 
> > I am testing the performance capabilities of the virtio-user exceptional path for use in container networking scenarios. I am trying to reproduce the results obtained in Test Case 1 described in the paper "VIRTIO-USER: A New Versatile Channel for Kernel-Bypass Networks".  That is, I am creating two virtio-user vdevs in testpmd, putting each one in separate network namespaces and running iperf3 between the two. However, I am unable to obtain the near 25Gbps throughput shown in the paper. Instead, I obtained a mere 3Gbps. Has anyone else been able to reproduce these results? My understanding is that this type of virtual device takes advantage of both checksum offloading and LRO in order to get such high throughput. However, for some reason, I am unable to use RX checksum offloading nor LRO in my setup. If I specify the --enable-lro and --enable-rx-cksum options in testpmd (as shown here https://doc.dpdk.org/guides-17.11/howto/virtio_user_as_exceptional_path.html), the tap device is never created in the kernel. If I do not specify these options, the tap is created correctly but the rx-checksum and LRO are off and cannot be turned on using ethtool (they are marked as [fixed]).
> 
> Somehow below fix isn't backported to 17.11 while the commit it fixed was backported.
> 
> https://git.dpdk.org/dpdk/commit/?id=bce7e9050f9b
> commit bce7e9050f9b ("net/virtio-user: fix start with kernel vhost")
> 
> Please apply above fix locally and see if it works.
> 
> Thanks
> 
> > 
> > Does anyone have any idea what may be preventing me from taking advantage of checksum offloading and LRO? Also, I am I right in assuming that this is the reason why the performance is so poor or could there be another problem with my setup? I am using DPDK 17.11 on CentOS 7.5. Any help would be appreciated.
> > 
> > Regards,
> > 
> > Eric
> >