Hi Matan
After rescan:
/sys/bus/pci/devices/0000:08:00.0/ directory is recreated.
“Ip a” command can detect the mlx5 NIC:
37: enp8s0f0np0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 04:e8:92:7d:dd:e4 brd ff:ff:ff:ff:ff:ff
How do I check the kernel netdev port you said?
Thanks!
发件人: Matan Azrad <matan@mellanox.com>
发送时间: 2023年8月29日
20:07
收件人: jiangheng (G) <jiangheng14@huawei.com>
主题: RE: net_mlx5: port 2 cannot get MAC address, is mlx5_en loaded? (errno: Function not implemented)
Hi
Jiangheng
After rescan: Do you see the kernel netdev port of the device?
Matan
From: jiangheng (G) <jiangheng14@huawei.com>
Sent: Tuesday, 29 August 2023 12:59
To: users@dpdk.org; Matan Azrad <matan@mellanox.com>
Cc: Caowangbao <caowangbao@huawei.com>; Yanan (Euler) <yanan@huawei.com>; liaichun <liaichun@huawei.com>
Subject: net_mlx5: port 2 cannot get MAC address, is mlx5_en loaded? (errno: Function not implemented)
External email: Use caution opening links or attachments
|
Hi matan:
I have enabled mlx5 hotplug based on the failsafe pmd:
"--vdev", "net_failsafe0,mac=04:e8:92:7d:dd:e4,dev(08:00.0)", "-b", "08:00.0"
08:00.0 is mlx5 NIC.
The app started successfully.
However, I had some problems verifying the hotplug function. Here are the steps:
echo 1 > /sys/bus/pci/devices/0000:08:00.0/remove
echo 1 > /sys/bus/pci/rescan
The app had the following error:
EAL: PCI device 0000:08:00.0 on NUMA socket 0
EAL: probe driver: 15b3:1017 net_mlx5
net_mlx5: port 2 cannot get MAC address, is mlx5_en loaded? (errno: Function not implemented)
net_mlx5: probe of PCI device 0000:08:00.0 aborted after encountering an error: No such device
EAL: Driver cannot attach the device (08:00.0)
EAL: Failed to attach device on primary process
net_failsafe: sub_device 0 probe failed (No such device)
Look at the code it is through the ioctl function to obtain the MAC address.
I wonder if there are other configurations that have not been done, causing this problem
Thanks!