From: Kamil Rytarowski <krytarowski@caviumnetworks.com>
To: <dev@dpdk.org>
Cc: <maciej.czekaj@caviumnetworks.com>, <zyta.szpak@semihalf.com>,
<slawomir.rosek@semihalf.com>, <rad@semihalf.com>,
<jerin.jacob@caviumnetworks.com>
Subject: Re: [dpdk-dev] [PATCH 00/13] Add support for secondary queue set in nicvf thunderx driver
Date: Mon, 12 Sep 2016 12:59:51 +0200 [thread overview]
Message-ID: <17abab9a-e19f-3a79-972f-0d554300c420@caviumnetworks.com> (raw)
In-Reply-To: <1472230448-17490-1-git-send-email-krytarowski@caviumnetworks.com>
ping
W dniu 26.08.2016 o 18:53, Kamil Rytarowski pisze:
> This series of patches adds support for secondary queue set in nicvf thunderx
> driver
>
> There are two types of VFs:
> - Primary VF
> - Secondary VF
>
> Each port consist of a primary VF and n secondary VF(s). Each VF provides 8
> Tx/Rx queues to a port. In case port is configured to use more than 8 queues,
> then it requires one (or more) secondary VF. Each secondary VF adds additional
> 8 queues to the queue set.
>
> During PMD driver initialization, the primary VF's are enumerated by checking the
> specific flag (see READY message). They are at the beginning of VF list (the remain
> ones are secondary VF's).
>
> The primary VFs are used as master queue sets. Secondary VFs provide
> additional queue sets for primary ones. If a port is configured for more then
> 8 queues then it will request for additional queues from secondary VFs.
>
> Secondary VFs cannot be shared between primary VFs.
>
> Primary VFs are present on the tail of the 'Network devices using kernel
> driver' list, secondary VFs are on the remaining tail of the list.
>
> The VNIC driver in the multiqueue setup works differently than other drivers
> like `ixgbe`. We need to bind separately each specific queue set device with
> the ``tools/dpdk-devbind.py`` utility.
>
> Depending on the hardware used, the kernel driver sets a threshold ``vf_id``.
> VFs that try to attach with an id below or equal to this boundary are
> considered primary VFs. VFs that try to attach with an id above this boundary
> are considered secondary VFs.
>
> This patchset also contains other cleanups and improvements like fixing
> erroneous checksum calculation and preparing the thunderx driver for the multi
> queue set feature support.
>
>
> These changes base on the following pending patches:
>
> [dpdk-dev,1/3] net/thunderx: remove generic passx references from the driver
> http://dpdk.org/dev/patchwork/patch/14963/
>
> [dpdk-dev,2/3] net/thunderx: introduce cqe_rx2 HW capability flag
> http://dpdk.org/dev/patchwork/patch/14964/
>
> [dpdk-dev,3/3] net/thunderx: add 81xx SoC support
> http://dpdk.org/dev/patchwork/patch/14965/
>
> Kamil Rytarowski (13):
> net/thunderx: cleanup the driver before adding new features
> net/thunderx: correct transmit checksum handling
> net/thunderx/base: add family of functions to store qsets
> net/thunderx/base: add secondary queue set support
> net/thunderx: add family of functions to store DPDK qsets
> net/thunderx: add secondary queue set in interrupt functions
> net/thunderx: fix multiprocess support in stats
> net/thunderx: add helper utils for secondary qset support
> net/thunderx: add secondary qset support in dev stop/close
> net/thunderx: add secondary qset support in device start
> net/thunderx: add secondary qset support in device configure
> net/thunderx: add final bits for secondary queue support
> net/thunderx: document secondary queue set support
>
> doc/guides/nics/thunderx.rst | 114 ++++-
> drivers/net/thunderx/Makefile | 2 +
> drivers/net/thunderx/base/nicvf_bsvf.c | 72 +++
> drivers/net/thunderx/base/nicvf_bsvf.h | 76 +++
> drivers/net/thunderx/base/nicvf_hw.c | 10 +-
> drivers/net/thunderx/base/nicvf_hw.h | 6 +-
> drivers/net/thunderx/base/nicvf_hw_defs.h | 1 +
> drivers/net/thunderx/base/nicvf_mbox.c | 34 +-
> drivers/net/thunderx/base/nicvf_mbox.h | 21 +-
> drivers/net/thunderx/nicvf_ethdev.c | 753 +++++++++++++++++++++---------
> drivers/net/thunderx/nicvf_ethdev.h | 39 ++
> drivers/net/thunderx/nicvf_rxtx.c | 14 +-
> drivers/net/thunderx/nicvf_struct.h | 6 +-
> drivers/net/thunderx/nicvf_svf.c | 78 ++++
> drivers/net/thunderx/nicvf_svf.h | 66 +++
> 15 files changed, 1046 insertions(+), 246 deletions(-)
> create mode 100644 drivers/net/thunderx/base/nicvf_bsvf.c
> create mode 100644 drivers/net/thunderx/base/nicvf_bsvf.h
> create mode 100644 drivers/net/thunderx/nicvf_svf.c
> create mode 100644 drivers/net/thunderx/nicvf_svf.h
>
next prev parent reply other threads:[~2016-09-12 11:00 UTC|newest]
Thread overview: 48+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-08-26 16:53 Kamil Rytarowski
2016-08-26 16:53 ` [dpdk-dev] [PATCH 01/13] net/thunderx: cleanup the driver before adding new features Kamil Rytarowski
2016-09-20 13:48 ` Ferruh Yigit
2016-09-29 14:21 ` Maciej Czekaj
2016-08-26 16:53 ` [dpdk-dev] [PATCH 02/13] net/thunderx: correct transmit checksum handling Kamil Rytarowski
2016-08-26 16:53 ` [dpdk-dev] [PATCH 03/13] net/thunderx/base: add family of functions to store qsets Kamil Rytarowski
2016-08-26 16:53 ` [dpdk-dev] [PATCH 04/13] net/thunderx/base: add secondary queue set support Kamil Rytarowski
2016-09-20 13:48 ` Ferruh Yigit
2016-09-29 14:22 ` Maciej Czekaj
2016-08-26 16:54 ` [dpdk-dev] [PATCH 05/13] net/thunderx: add family of functions to store DPDK qsets Kamil Rytarowski
2016-08-26 16:54 ` [dpdk-dev] [PATCH 06/13] net/thunderx: add secondary queue set in interrupt functions Kamil Rytarowski
2016-08-26 16:54 ` [dpdk-dev] [PATCH 07/13] net/thunderx: fix multiprocess support in stats Kamil Rytarowski
2016-09-20 13:48 ` Ferruh Yigit
2016-09-29 14:35 ` Maciej Czekaj
2016-08-26 16:54 ` [dpdk-dev] [PATCH 08/13] net/thunderx: add helper utils for secondary qset support Kamil Rytarowski
2016-08-26 16:54 ` [dpdk-dev] [PATCH 09/13] net/thunderx: add secondary qset support in dev stop/close Kamil Rytarowski
2016-08-26 16:54 ` [dpdk-dev] [PATCH 10/13] net/thunderx: add secondary qset support in device start Kamil Rytarowski
2016-08-26 16:54 ` [dpdk-dev] [PATCH 11/13] net/thunderx: add secondary qset support in device configure Kamil Rytarowski
2016-08-26 16:54 ` [dpdk-dev] [PATCH 12/13] net/thunderx: add final bits for secondary queue support Kamil Rytarowski
2016-09-20 13:49 ` Ferruh Yigit
2016-09-29 14:37 ` Maciej Czekaj
2016-08-26 16:54 ` [dpdk-dev] [PATCH 13/13] net/thunderx: document secondary queue set support Kamil Rytarowski
2016-09-26 20:17 ` Mcnamara, John
2016-09-29 14:38 ` Maciej Czekaj
2016-09-12 10:59 ` Kamil Rytarowski [this message]
2016-09-19 12:23 ` [dpdk-dev] [PATCH 00/13] Add support for secondary queue set in nicvf thunderx driver Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 00/15] " Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 01/15] net/thunderx: cleanup the driver before adding new features Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 02/15] net/thunderx: correct transmit checksum handling Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 03/15] net/thunderx/base: add family of functions to store qsets Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 04/15] net/thunderx/base: add secondary queue set support Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 05/15] net/thunderx: add family of functions to store DPDK qsets Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 06/15] net/thunderx: add secondary queue set in interrupt functions Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 07/15] net/thunderx: remove problematic private_data->eth_dev link Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 08/15] net/thunderx: add helper utils for secondary qset support Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 09/15] net/thunderx: add secondary qset support in dev stop/close Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 10/15] net/thunderx: add secondary qset support in device start Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 11/15] net/thunderx: add secondary qset support in device configure Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 12/15] net/thunderx: add final bits for secondary queue support Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 13/15] net/thunderx: document secondary queue set support Kamil Rytarowski
2016-09-30 15:12 ` Mcnamara, John
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 14/15] ethdev: Support VFs on the different PCI domains Kamil Rytarowski
2016-10-10 10:19 ` Ferruh Yigit
2016-10-10 13:01 ` Kamil Rytarowski
2016-10-10 13:27 ` Ferruh Yigit
2016-10-11 13:52 ` Kamil Rytarowski
2016-09-30 12:05 ` [dpdk-dev] [PATCH v2 15/15] net/thunderx: Bump driver version to 2.0 Kamil Rytarowski
2016-10-12 15:59 ` [dpdk-dev] [PATCH v2 00/15] Add support for secondary queue set in nicvf thunderx driver Bruce Richardson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=17abab9a-e19f-3a79-972f-0d554300c420@caviumnetworks.com \
--to=krytarowski@caviumnetworks.com \
--cc=dev@dpdk.org \
--cc=jerin.jacob@caviumnetworks.com \
--cc=maciej.czekaj@caviumnetworks.com \
--cc=rad@semihalf.com \
--cc=slawomir.rosek@semihalf.com \
--cc=zyta.szpak@semihalf.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).