[dpdk-dev] [PATCH v1 5/7] e1000: check lsc and rxq not enable in the same time

[Yong Liu <yong.liu@intel.com>]

From: Marvin Liu <yong.liu@intel.com>

e1000 only support one type of interrupt cause, so remove lsc interrupt
handler if rxq enabled.

Signed-off-by: Marvin Liu <yong.liu@intel.com>

diff --git a/drivers/net/e1000/em_ethdev.c b/drivers/net/e1000/em_ethdev.c
index 5d94b55..920d814 100644
--- a/drivers/net/e1000/em_ethdev.c
+++ b/drivers/net/e1000/em_ethdev.c
@@ -630,14 +630,22 @@ eth_em_start(struct rte_eth_dev *dev)
 	}
 	e1000_setup_link(hw);
 
-	/* check if lsc interrupt feature is enabled */
-	if (dev->data->dev_conf.intr_conf.lsc != 0) {
-		ret = eth_em_interrupt_setup(dev);
-		if (ret) {
-			PMD_INIT_LOG(ERR, "Unable to setup interrupts");
-			em_dev_clear_queues(dev);
-			return ret;
-		}
+	if (rte_intr_allow_others(intr_handle)) {
+		/* check if lsc interrupt is enabled */
+		if (dev->data->dev_conf.intr_conf.lsc != 0)
+			ret = eth_em_interrupt_setup(dev);
+			if (ret) {
+				PMD_INIT_LOG(ERR, "Unable to setup interrupts");
+				em_dev_clear_queues(dev);
+				return ret;
+			}
+	} else {
+		rte_intr_callback_unregister(intr_handle,
+						eth_em_interrupt_handler,
+						(void *)dev);
+		if (dev->data->dev_conf.intr_conf.lsc != 0)
+			PMD_INIT_LOG(INFO, "lsc won't enable because of"
+				     " no intr multiplex\n");
 	}
 	/* check if rxq interrupt is enabled */
 	if (dev->data->dev_conf.intr_conf.rxq != 0)
@@ -687,6 +695,13 @@ eth_em_stop(struct rte_eth_dev *dev)
 	/* clear the recorded link status */
 	memset(&link, 0, sizeof(link));
 	rte_em_dev_atomic_write_link_status(dev, &link);
+
+	if (!rte_intr_allow_others(intr_handle))
+		/* resume to the default handler */
+		rte_intr_callback_register(intr_handle,
+					   eth_em_interrupt_handler,
+					   (void *)dev);
+
 	/* Clean datapath event and queue/vec mapping */
 	rte_intr_efd_disable(intr_handle);
 	if (intr_handle->intr_vec != NULL) {
-- 
1.9.3