DPDK patches and discussions
 help / color / mirror / Atom feed
From: Alejandro Lucero <alejandro.lucero@netronome.com>
To: dev@dpdk.org
Subject: [dpdk-dev] [PATCH v9 7/9] nfp: link status change interrupt support
Date: Thu, 26 Nov 2015 09:49:27 +0000	[thread overview]
Message-ID: <1448531369-8808-8-git-send-email-alejandro.lucero@netronome.com> (raw)
In-Reply-To: <1448531369-8808-1-git-send-email-alejandro.lucero@netronome.com>

Signed-off-by: Alejandro Lucero <alejandro.lucero@netronome.com>
Signed-off-by: Rolf Neugebauer <rolf.neugebauer@netronome.com>
---
 drivers/net/nfp/nfp_net.c |  123 +++++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 123 insertions(+)

diff --git a/drivers/net/nfp/nfp_net.c b/drivers/net/nfp/nfp_net.c
index 5383f51..3763790 100644
--- a/drivers/net/nfp/nfp_net.c
+++ b/drivers/net/nfp/nfp_net.c
@@ -73,6 +73,9 @@
 /* Prototypes */
 static void nfp_net_close(struct rte_eth_dev *dev);
 static int nfp_net_configure(struct rte_eth_dev *dev);
+static void nfp_net_dev_interrupt_handler(struct rte_intr_handle *handle,
+					  void *param);
+static void nfp_net_dev_interrupt_delayed_handler(void *param);
 static int nfp_net_dev_mtu_set(struct rte_eth_dev *dev, uint16_t mtu);
 static void nfp_net_infos_get(struct rte_eth_dev *dev,
 			      struct rte_eth_dev_info *dev_info);
@@ -731,6 +734,7 @@ nfp_net_close(struct rte_eth_dev *dev)
 
 	nfp_net_stop(dev);
 
+	rte_intr_disable(&dev->pci_dev->intr_handle);
 	nn_cfg_writeb(hw, NFP_NET_CFG_LSC, 0xff);
 
 	/*
@@ -1115,6 +1119,114 @@ nfp_net_rx_queue_count(struct rte_eth_dev *dev, uint16_t queue_idx)
 	return count;
 }
 
+static void
+nfp_net_dev_link_status_print(struct rte_eth_dev *dev)
+{
+	struct rte_eth_link link;
+
+	memset(&link, 0, sizeof(link));
+	nfp_net_dev_atomic_read_link_status(dev, &link);
+	if (link.link_status)
+		RTE_LOG(INFO, PMD, "Port %d: Link Up - speed %u Mbps - %s\n",
+			(int)(dev->data->port_id), (unsigned)link.link_speed,
+			link.link_duplex == ETH_LINK_FULL_DUPLEX
+			? "full-duplex" : "half-duplex");
+	else
+		RTE_LOG(INFO, PMD, " Port %d: Link Down\n",
+			(int)(dev->data->port_id));
+
+	RTE_LOG(INFO, PMD, "PCI Address: %04d:%02d:%02d:%d\n",
+		dev->pci_dev->addr.domain, dev->pci_dev->addr.bus,
+		dev->pci_dev->addr.devid, dev->pci_dev->addr.function);
+}
+
+/* Interrupt configuration and handling */
+
+/*
+ * nfp_net_irq_unmask - Unmask an interrupt
+ *
+ * If MSI-X auto-masking is enabled clear the mask bit, otherwise
+ * clear the ICR for the entry.
+ */
+static void
+nfp_net_irq_unmask(struct rte_eth_dev *dev)
+{
+	struct nfp_net_hw *hw;
+
+	hw = NFP_NET_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+
+	if (hw->ctrl & NFP_NET_CFG_CTRL_MSIXAUTO) {
+		/* If MSI-X auto-masking is used, clear the entry */
+		rte_wmb();
+		rte_intr_enable(&dev->pci_dev->intr_handle);
+	} else {
+		/* Make sure all updates are written before un-masking */
+		rte_wmb();
+		nn_cfg_writeb(hw, NFP_NET_CFG_ICR(NFP_NET_IRQ_LSC_IDX),
+			      NFP_NET_CFG_ICR_UNMASKED);
+	}
+}
+
+static void
+nfp_net_dev_interrupt_handler(__rte_unused struct rte_intr_handle *handle,
+			      void *param)
+{
+	int64_t timeout;
+	struct rte_eth_link link;
+	struct rte_eth_dev *dev = (struct rte_eth_dev *)param;
+
+	PMD_DRV_LOG(DEBUG, "We got a LSC interrupt!!!\n");
+
+	/* get the link status */
+	memset(&link, 0, sizeof(link));
+	nfp_net_dev_atomic_read_link_status(dev, &link);
+
+	nfp_net_link_update(dev, 0);
+
+	/* likely to up */
+	if (!link.link_status) {
+		/* handle it 1 sec later, wait it being stable */
+		timeout = NFP_NET_LINK_UP_CHECK_TIMEOUT;
+		/* likely to down */
+	} else {
+		/* handle it 4 sec later, wait it being stable */
+		timeout = NFP_NET_LINK_DOWN_CHECK_TIMEOUT;
+	}
+
+	if (rte_eal_alarm_set(timeout * 1000,
+			      nfp_net_dev_interrupt_delayed_handler,
+			      (void *)dev) < 0) {
+		RTE_LOG(ERR, PMD, "Error setting alarm");
+		/* Unmasking */
+		nfp_net_irq_unmask(dev);
+	}
+}
+
+/*
+ * Interrupt handler which shall be registered for alarm callback for delayed
+ * handling specific interrupt to wait for the stable nic state. As the NIC
+ * interrupt state is not stable for nfp after link is just down, it needs
+ * to wait 4 seconds to get the stable status.
+ *
+ * @param handle   Pointer to interrupt handle.
+ * @param param    The address of parameter (struct rte_eth_dev *)
+ *
+ * @return  void
+ */
+static void
+nfp_net_dev_interrupt_delayed_handler(void *param)
+{
+	struct rte_eth_dev *dev = (struct rte_eth_dev *)param;
+
+	nfp_net_link_update(dev, 0);
+	_rte_eth_dev_callback_process(dev, RTE_ETH_EVENT_INTR_LSC);
+
+	nfp_net_dev_link_status_print(dev);
+
+	/* Unmasking */
+	nfp_net_irq_unmask(dev);
+}
+
 static int
 nfp_net_dev_mtu_set(struct rte_eth_dev *dev, uint16_t mtu)
 {
@@ -2315,6 +2427,17 @@ nfp_net_init(struct rte_eth_dev *eth_dev)
 		     hw->mac_addr[0], hw->mac_addr[1], hw->mac_addr[2],
 		     hw->mac_addr[3], hw->mac_addr[4], hw->mac_addr[5]);
 
+	/* Registering LSC interrupt handler */
+	rte_intr_callback_register(&pci_dev->intr_handle,
+				   nfp_net_dev_interrupt_handler,
+				   (void *)eth_dev);
+
+	/* enable uio intr after callback register */
+	rte_intr_enable(&pci_dev->intr_handle);
+
+	/* Telling the firmware about the LSC interrupt entry */
+	nn_cfg_writeb(hw, NFP_NET_CFG_LSC, NFP_NET_IRQ_LSC_IDX);
+
 	/* Recording current stats counters values */
 	nfp_net_stats_reset(eth_dev);
 
-- 
1.7.9.5

  parent reply	other threads:[~2015-11-26  9:49 UTC|newest]

Thread overview: 13+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-11-26  9:49 [dpdk-dev] [PATCH v9 0/9] support for netronome nfp-6xxx card Alejandro Lucero
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 1/9] nfp: basic initialization Alejandro Lucero
2015-11-26 18:14   ` Stephen Hemminger
2015-11-27  7:51     ` Alejandro Lucero
2015-11-27  9:18       ` Thomas Monjalon
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 2/9] nfp: adding rx/tx functionality Alejandro Lucero
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 3/9] nfp: adding rss Alejandro Lucero
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 4/9] nfp: adding stats Alejandro Lucero
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 5/9] nfp: adding link functionality Alejandro Lucero
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 6/9] nfp: adding extra functionality Alejandro Lucero
2015-11-26  9:49 ` Alejandro Lucero [this message]
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 8/9] nfp: adding nic guide Alejandro Lucero
2015-11-26  9:49 ` [dpdk-dev] [PATCH v9 9/9] nfp: updating maintainers Alejandro Lucero

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1448531369-8808-8-git-send-email-alejandro.lucero@netronome.com \
    --to=alejandro.lucero@netronome.com \
    --cc=dev@dpdk.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).