[PATCH 1/6] net/hns3: cancel heartbeat alarm when VF reset

[Dongdong Liu <liudongdong3@huawei.com>]

From: Huisong Li <lihuisong@huawei.com>

The purpose of the heartbeat alarm is to keep alive for VF. The mailbox
channel is disabled when VF is reset, and the heartbeat mailbox message
will fail to send. If the reset is not complete, the error information
about the heartbeat sending failure will be printed continuously.
In fact, VF does set alive when VF restore its configuration. So the
heartbeat alarm can be canceled to prepare to start reset and start the
alarm when start service.

Signed-off-by: Huisong Li <lihuisong@huawei.com>
---
 drivers/net/hns3/hns3_ethdev_vf.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/net/hns3/hns3_ethdev_vf.c b/drivers/net/hns3/hns3_ethdev_vf.c
index 6c8940fde5..2ac712ec77 100644
--- a/drivers/net/hns3/hns3_ethdev_vf.c
+++ b/drivers/net/hns3/hns3_ethdev_vf.c
@@ -1977,6 +1977,8 @@ hns3vf_stop_service(struct hns3_adapter *hns)
 	} else
 		hw->reset.mbuf_deferred_free = false;
 
+	rte_eal_alarm_cancel(hns3vf_keep_alive_handler, eth_dev);
+
 	/*
 	 * It is cumbersome for hardware to pick-and-choose entries for deletion
 	 * from table space. Hence, for function reset software intervention is
@@ -1998,6 +2000,10 @@ hns3vf_start_service(struct hns3_adapter *hns)
 	eth_dev = &rte_eth_devices[hw->data->port_id];
 	hns3_set_rxtx_function(eth_dev);
 	hns3_mp_req_start_rxtx(eth_dev);
+
+	rte_eal_alarm_set(HNS3VF_KEEP_ALIVE_INTERVAL, hns3vf_keep_alive_handler,
+			  eth_dev);
+
 	if (hw->adapter_state == HNS3_NIC_STARTED) {
 		hns3vf_start_poll_job(eth_dev);
 
-- 
2.22.0