[PATCH] net/mlx5: forbid MPRQ restart

[Alexander Kozyrev <akozyrev@nvidia.com>]

The queue restart is only supported by the non-vectorized
single-packet receive queue today. Restarting MPRQ will
result in corrupted packets because of CQE and WQE mismatch.
Prevent this by not allowing the MPRQ Rx queue stop.

Fixes: 161d103b23 ("net/mlx5: add queue start and stop")
Cc: stable@dpdk.org

Signed-off-by: Alexander Kozyrev <akozyrev@nvidia.com>
---
 drivers/net/mlx5/mlx5_rxq.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/net/mlx5/mlx5_rxq.c b/drivers/net/mlx5/mlx5_rxq.c
index ad8fd13cbe..b314c0482b 100644
--- a/drivers/net/mlx5/mlx5_rxq.c
+++ b/drivers/net/mlx5/mlx5_rxq.c
@@ -531,12 +531,12 @@ mlx5_rx_queue_stop(struct rte_eth_dev *dev, uint16_t idx)
 	 * synchronized, that might be broken on RQ restart
 	 * and cause Rx malfunction, so queue stopping is
 	 * not supported if vectorized Rx burst is engaged.
-	 * The routine pointer depends on the process
-	 * type, should perform check there.
+	 * The routine pointer depends on the process type,
+	 * should perform check there. MPRQ is not supported as well.
 	 */
-	if (pkt_burst == mlx5_rx_burst_vec) {
-		DRV_LOG(ERR, "Rx queue stop is not supported "
-			"for vectorized Rx");
+	if (pkt_burst != mlx5_rx_burst) {
+		DRV_LOG(ERR, "Rx queue stop is only supported "
+			"for non-vectorized single-packet Rx");
 		rte_errno = EINVAL;
 		return -EINVAL;
 	}
-- 
2.18.2