From: Venkat Kumar Ande <venkatkumar.ande@amd.com>
To: <dev@dpdk.org>
Cc: <Selwin.Sebastian@amd.com>,
Venkat Kumar Ande <VenkatKumar.Ande@amd.com>, <stable@dpdk.org>,
Selwin Sebastian <selwin.sebastian@amd.com>
Subject: [PATCH v3 01/25] net/axgbe: fix mdio access for non-zero ports and CL45 PHYs
Date: Tue, 4 Jun 2024 17:41:33 +0530 [thread overview]
Message-ID: <20240604121157.3052-1-venkatkumar.ande@amd.com> (raw)
In-Reply-To: <20240507124305.2318-1-VenkatKumar.Ande@amd.com>
From: Venkat Kumar Ande <VenkatKumar.Ande@amd.com>
The XGBE supports performing MDIO operations using an MDIO command
request. The driver mistakenly uses the mdio port address as the
MDIO command request device address instead of the MDIO command
request port address. Additionally, the driver does not properly check
for and create a clause 45 MDIO command
Without the fix PHY device is not detected and can't be usable.
Check the supplied MDIO register to determine if the request is a clause
45 operation (MII_ADDR_C45). For a clause 45 operation, extract device
address and register number from the supplied MDIO register and use them
to set the MDIO command request device address and register number fields.
For a clause 22 operation, the MDIO request device address is set to zero
and the MDIO command request register number is set to the supplied MDIO
register. In either case, the supplied MDIO port address is used as the
MDIO command request port address.
Fixes: 4ac7516b8b39 ("net/axgbe: add phy init and related APIs")
Cc: stable@dpdk.org
Signed-off-by: Venkat Kumar Ande <VenkatKumar.Ande@amd.com>
Acked-by: Selwin Sebastian <selwin.sebastian@amd.com>
---
drivers/net/axgbe/axgbe_common.h | 2 --
drivers/net/axgbe/axgbe_dev.c | 22 ++++++++++++++++------
2 files changed, 16 insertions(+), 8 deletions(-)
diff --git a/drivers/net/axgbe/axgbe_common.h b/drivers/net/axgbe/axgbe_common.h
index a5d11c5832..51532fb34a 100644
--- a/drivers/net/axgbe/axgbe_common.h
+++ b/drivers/net/axgbe/axgbe_common.h
@@ -407,8 +407,6 @@
#define MAC_MDIOSCAR_PA_WIDTH 5
#define MAC_MDIOSCAR_RA_INDEX 0
#define MAC_MDIOSCAR_RA_WIDTH 16
-#define MAC_MDIOSCAR_REG_INDEX 0
-#define MAC_MDIOSCAR_REG_WIDTH 21
#define MAC_MDIOSCCDR_BUSY_INDEX 22
#define MAC_MDIOSCCDR_BUSY_WIDTH 1
#define MAC_MDIOSCCDR_CMD_INDEX 16
diff --git a/drivers/net/axgbe/axgbe_dev.c b/drivers/net/axgbe/axgbe_dev.c
index 6a7fddffca..3389954aa6 100644
--- a/drivers/net/axgbe/axgbe_dev.c
+++ b/drivers/net/axgbe/axgbe_dev.c
@@ -63,15 +63,27 @@ static int mdio_complete(struct axgbe_port *pdata)
return 0;
}
+static unsigned int axgbe_create_mdio_sca(int port, int reg)
+{
+ unsigned int mdio_sca, da;
+
+ da = (reg & MII_ADDR_C45) ? reg >> 16 : 0;
+
+ mdio_sca = 0;
+ AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, RA, reg);
+ AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, PA, port);
+ AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, DA, da);
+
+ return mdio_sca;
+}
+
static int axgbe_write_ext_mii_regs(struct axgbe_port *pdata, int addr,
int reg, u16 val)
{
unsigned int mdio_sca, mdio_sccd;
uint64_t timeout;
- mdio_sca = 0;
- AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, REG, reg);
- AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, DA, addr);
+ mdio_sca = axgbe_create_mdio_sca(addr, reg);
AXGMAC_IOWRITE(pdata, MAC_MDIOSCAR, mdio_sca);
mdio_sccd = 0;
@@ -97,9 +109,7 @@ static int axgbe_read_ext_mii_regs(struct axgbe_port *pdata, int addr,
unsigned int mdio_sca, mdio_sccd;
uint64_t timeout;
- mdio_sca = 0;
- AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, REG, reg);
- AXGMAC_SET_BITS(mdio_sca, MAC_MDIOSCAR, DA, addr);
+ mdio_sca = axgbe_create_mdio_sca(addr, reg);
AXGMAC_IOWRITE(pdata, MAC_MDIOSCAR, mdio_sca);
mdio_sccd = 0;
--
2.34.1
next parent reply other threads:[~2024-06-04 12:12 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <20240507124305.2318-1-VenkatKumar.Ande@amd.com>
2024-06-04 12:11 ` Venkat Kumar Ande [this message]
2024-06-04 12:11 ` [PATCH v3 02/25] net/axgbe: reset link when the link never comes back Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 03/25] net/axgbe: fix fluctuations for 1G BELFUSE SFP Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 04/25] net/axgbe: update DMA coherency values Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 05/25] net/axgbe: disable interrupts during device removal Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 06/25] net/axgbe: yellow carp devices do not need rrc Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 07/25] net/axgbe: enable PLL control for fixed PHY modes only Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 08/25] net/axgbe: fix the SFP codes check for DAC cables Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 09/25] net/axgbe: fix logic around active and passive cables Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 10/25] net/axgbe: check only the minimum speed for cables Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 11/25] net/axgbe: flow Tx Ctrl Registers are h/w version dependent Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 12/25] net/axgbe: delay AN timeout during KR training Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 13/25] net/axgbe: fix the false linkup in axgbe PHY status Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 14/25] net/axgbe: remove use of comm owned field Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 15/25] net/axgbe: remove field of SFP diagnostic support Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 16/25] net/axgbe: improve SFP 100Mbps auto-negotiation Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 17/25] net/axgbe: remove unnecessary conversion to bool Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 18/25] net/axgbe: use definitions for mailbox commands Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 19/25] net/axgbe: add support for 10 Mbps speed Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 20/25] net/axgbe: separate C22 and C45 transactions Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 21/25] net/axgbe: replace mii generic macro for c45 with AXGBE Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 22/25] net/axgbe: add 2.5GbE support to 10G BaseT mode Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 23/25] net/axgbe: add support for Rx adaptation Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 24/25] net/axgbe: extend 10Mbps support to MAC version 21H Venkat Kumar Ande
2024-06-04 12:11 ` [PATCH v3 25/25] net/axgbe: modify debug messages Venkat Kumar Ande
2024-06-05 17:07 ` [PATCH v3 01/25] net/axgbe: fix mdio access for non-zero ports and CL45 PHYs Ferruh Yigit
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240604121157.3052-1-venkatkumar.ande@amd.com \
--to=venkatkumar.ande@amd.com \
--cc=Selwin.Sebastian@amd.com \
--cc=dev@dpdk.org \
--cc=stable@dpdk.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).