Firmware version: h-5.1# ethtool -i eth0 driver: bnxt_en version: 5.10.110-yocto-standard firmware-version: 20.8.187.0/pkg 20.8.29.0 expansion-rom-version: bus-info: 0000:00:03.0 supports-statistics: yes supports-test: no supports-eeprom-access: no supports-register-dump: no supports-priv-flags: no Here is the lcpic o/p executing lspci -vv 00:00.0 Host bridge: Intel Corporation 440FX - 82441FX PMC [Natoma] (rev 02) Subsystem: Red Hat, Inc. Qemu virtual machine Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx- Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR- TAbort- SERR- TAbort- SERR- TAbort- SERR- TAbort- SERR- TAbort- SERR- TAbort- SERR- TAbort- SERR- BAR=0 offset=00000000 size=00000000 Capabilities: [70] Vendor Specific Information: VirtIO: Notify BAR=4 offset=00003000 size=00001000 multiplier=00000004 Capabilities: [60] Vendor Specific Information: VirtIO: DeviceCfg BAR=4 offset=00002000 size=00001000 Capabilities: [50] Vendor Specific Information: VirtIO: ISR BAR=4 offset=00001000 size=00001000 Capabilities: [40] Vendor Specific Information: VirtIO: CommonCfg BAR=4 offset=00000000 size=00001000 Kernel driver in use: virtio-pci 00:05.0 Ethernet controller: Broadcom Inc. and subsidiaries NetXtreme-E Ethernet Virtual Function Subsystem: Oracle/SUN Device 16d7 Physical Slot: 5 Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR- TAbort- SERR- wrote: > On Tue, Oct 18, 2022 at 11:24 PM Nageswara Rao wrote: > > > > Hi, > > > > Recently we upgraded from DPDK-19.11 to DPDK-21.11. Post upgrade, on OCI > VM.Standard2.8, we are observing packet drop due invalid IP > length/truncated packets for the TCP & UDP traffic. However ping packets > are going through without any issue. > > > > > > This issue is seen with OCI SRIOV bnxt driver. Please find attached > corresponding DPDK logs. > > > > Can you please check the logs and let me know if there are any known > issues or we are missing any configuration here? Appreciate your help. > > Hi, > Can you share the firmware version on the NIC? > Also can you share the output of lspci - it will help to know which > variant of NIC you are using. > > Thanks > > > > > > > > Thanks > > > > Nagesh >