From: "Sujith Sankar (ssujith)" <ssujith@cisco.com>
To: David Marchand <david.marchand@6wind.com>
Cc: "dev@dpdk.org" <dev@dpdk.org>
Subject: Re: [dpdk-dev] [PATCH] enicpmd: replace the type u_int* with uint* to remove compilation errors on a few platforms
Date: Fri, 28 Nov 2014 09:24:26 +0000 [thread overview]
Message-ID: <D09E3BEE.2905A%ssujith@cisco.com> (raw)
In-Reply-To: <CALwxeUsObyGCO_AW_fJkaSi+n1M4_5O3RQEuL+RX8xHZcVogCg@mail.gmail.com>
Hi David,
The u8, u16, etc are there because enicpmd shares a lot of code with kernel mode driver and these are used at a lot of places.
I agree with you on bringing in consistency. Let me change ioread16 with uint16 and upload a new patch.
Hope this is ok with you.
Thanks,
-Sujith
From: David Marchand <david.marchand@6wind.com<mailto:david.marchand@6wind.com>>
Date: Friday, 28 November 2014 2:18 pm
To: "Sujith Sankar (ssujith)" <ssujith@cisco.com<mailto:ssujith@cisco.com>>
Cc: "dev@dpdk.org<mailto:dev@dpdk.org>" <dev@dpdk.org<mailto:dev@dpdk.org>>
Subject: Re: [dpdk-dev] [PATCH] enicpmd: replace the type u_int* with uint* to remove compilation errors on a few platforms
Hello Sujith,
Why keep those u8, u16, u32 etc... ?
Especially, you can see in this patch that the ioread16 uses u16, while ioread8, ioread32 uses uint*.
I like consistency and "standard" types (unless there is a reason why we use different types).
Anyway, this patch builds fine on ppc.
--
David Marchand
On Fri, Nov 28, 2014 at 8:02 AM, Sujith Sankar <ssujith@cisco.com<mailto:ssujith@cisco.com>> wrote:
ENIC PMD was giving compilation errors on ppc_64-power8-linuxapp-gcc because
of types such as u_int32_t. This patch replaces all those with uint32_t and
similar ones.
Reported-by: David Marchand <david.marchand@6wind.com<mailto:david.marchand@6wind.com>>
Signed-off-by: Sujith Sankar <ssujith@cisco.com<mailto:ssujith@cisco.com>>
---
lib/librte_pmd_enic/enic.h | 2 +-
lib/librte_pmd_enic/enic_compat.h | 16 ++++++++--------
lib/librte_pmd_enic/enic_main.c | 18 +++++++++---------
lib/librte_pmd_enic/vnic/vnic_devcmd.h | 6 +++---
4 files changed, 21 insertions(+), 21 deletions(-)
diff --git a/lib/librte_pmd_enic/enic.h b/lib/librte_pmd_enic/enic.h
index 9f80fc0..6400d24 100644
--- a/lib/librte_pmd_enic/enic.h
+++ b/lib/librte_pmd_enic/enic.h
@@ -106,7 +106,7 @@ struct enic {
int iommu_group_fd;
int iommu_groupid;
int eventfd;
- u_int8_t mac_addr[ETH_ALEN];
+ uint8_t mac_addr[ETH_ALEN];
pthread_t err_intr_thread;
int promisc;
int allmulti;
diff --git a/lib/librte_pmd_enic/enic_compat.h b/lib/librte_pmd_enic/enic_compat.h
index d22578e..7c62bf2 100644
--- a/lib/librte_pmd_enic/enic_compat.h
+++ b/lib/librte_pmd_enic/enic_compat.h
@@ -89,9 +89,9 @@ typedef unsigned int u32;
typedef unsigned long long u64;
typedef unsigned long long dma_addr_t;
-static inline u_int32_t ioread32(volatile void *addr)
+static inline uint32_t ioread32(volatile void *addr)
{
- return *(volatile u_int32_t *)addr;
+ return *(volatile uint32_t *)addr;
}
static inline u16 ioread16(volatile void *addr)
@@ -99,14 +99,14 @@ static inline u16 ioread16(volatile void *addr)
return *(volatile u16 *)addr;
}
-static inline u_int8_t ioread8(volatile void *addr)
+static inline uint8_t ioread8(volatile void *addr)
{
- return *(volatile u_int8_t *)addr;
+ return *(volatile uint8_t *)addr;
}
-static inline void iowrite32(u_int32_t val, volatile void *addr)
+static inline void iowrite32(uint32_t val, volatile void *addr)
{
- *(volatile u_int32_t *)addr = val;
+ *(volatile uint32_t *)addr = val;
}
static inline void iowrite16(u16 val, volatile void *addr)
@@ -114,9 +114,9 @@ static inline void iowrite16(u16 val, volatile void *addr)
*(volatile u16 *)addr = val;
}
-static inline void iowrite8(u_int8_t val, volatile void *addr)
+static inline void iowrite8(uint8_t val, volatile void *addr)
{
- *(volatile u_int8_t *)addr = val;
+ *(volatile uint8_t *)addr = val;
}
static inline unsigned int readl(volatile void __iomem *addr)
diff --git a/lib/librte_pmd_enic/enic_main.c b/lib/librte_pmd_enic/enic_main.c
index f6f00d3..853dd04 100644
--- a/lib/librte_pmd_enic/enic_main.c
+++ b/lib/librte_pmd_enic/enic_main.c
@@ -172,17 +172,17 @@ unsigned int enic_cleanup_wq(struct enic *enic, struct vnic_wq *wq)
int enic_send_pkt(struct enic *enic, struct vnic_wq *wq,
struct rte_mbuf *tx_pkt, unsigned short len,
- u_int8_t sop, u_int8_t eop,
- u_int16_t ol_flags, u_int16_t vlan_tag)
+ uint8_t sop, uint8_t eop,
+ uint16_t ol_flags, uint16_t vlan_tag)
{
struct wq_enet_desc *desc = vnic_wq_next_desc(wq);
- u_int16_t mss = 0;
- u_int16_t header_length = 0;
- u_int8_t cq_entry = eop;
- u_int8_t vlan_tag_insert = 0;
+ uint16_t mss = 0;
+ uint16_t header_length = 0;
+ uint8_t cq_entry = eop;
+ uint8_t vlan_tag_insert = 0;
unsigned char *buf = (unsigned char *)(tx_pkt->buf_addr) +
RTE_PKTMBUF_HEADROOM;
- u_int64_t bus_addr = (dma_addr_t)
+ uint64_t bus_addr = (dma_addr_t)
(tx_pkt->buf_physaddr + RTE_PKTMBUF_HEADROOM);
if (sop) {
@@ -342,8 +342,8 @@ static int enic_rq_alloc_buf(struct vnic_rq *rq)
void *buf;
dma_addr_t dma_addr;
struct rq_enet_desc *desc = vnic_rq_next_desc(rq);
- u_int8_t type = RQ_ENET_TYPE_ONLY_SOP;
- u_int16_t len = ENIC_MAX_MTU + VLAN_ETH_HLEN;
+ uint8_t type = RQ_ENET_TYPE_ONLY_SOP;
+ uint16_t len = ENIC_MAX_MTU + VLAN_ETH_HLEN;
u16 split_hdr_size = vnic_get_hdr_split_size(enic->vdev);
struct rte_mbuf *mbuf = enic_rxmbuf_alloc(rq->mp);
struct rte_mbuf *hdr_mbuf = NULL;
diff --git a/lib/librte_pmd_enic/vnic/vnic_devcmd.h b/lib/librte_pmd_enic/vnic/vnic_devcmd.h
index b4c87c1..e7ecf31 100644
--- a/lib/librte_pmd_enic/vnic/vnic_devcmd.h
+++ b/lib/librte_pmd_enic/vnic/vnic_devcmd.h
@@ -691,9 +691,9 @@ enum {
#define FILTER_MAX_BUF_SIZE 100 /* Maximum size of buffer to CMD_ADD_FILTER */
struct filter_tlv {
- u_int32_t type;
- u_int32_t length;
- u_int32_t val[0];
+ uint32_t type;
+ uint32_t length;
+ uint32_t val[0];
};
enum {
--
1.9.1
prev parent reply other threads:[~2014-11-28 9:24 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-11-28 7:02 Sujith Sankar
2014-11-28 8:48 ` David Marchand
2014-11-28 9:24 ` Sujith Sankar (ssujith) [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=D09E3BEE.2905A%ssujith@cisco.com \
--to=ssujith@cisco.com \
--cc=david.marchand@6wind.com \
--cc=dev@dpdk.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).